RMR Installation Instructions
Do this before installing your slide internals, or remove the slide internals first!
The holes for the RMR are threaded to 6-32.

1. Degrease the thread holes with rubbing alcohol
2. Use the screws that came with your RMR. The Cover plates screws that came with your slide will be too short to secure the RMR.
3. Place the sealing plate between the RMR and the slide.
4. Test fit the screws first
5. The left screw may need to be shortened 1-2 threads.
6. The right screw may been to be shortered 3-4 threads. 
 7. If the right screw is too long it can impede on the action of the extractor plunger and rounds may fail to feed or fail to extract.
8. Look through the back of the slide to see if the screw is going into the extractor plunger hole.
9. Use a file to shorten the screws as needed.
10. Once the screws are the proper length, use blue locktite to secure them. Take care not to allow excess locktite to run into the slide.
11. Tighten the screws until pressure from one finger can cause the Allen wrench to bend in the stopped position.
12. Wait 24 hours after applying locktite before live fire with the slide.

Deltapoint Pro Installation Instructions
Do this before installing you slide internals, or remove the slide internals first!
The holes for the Deltapoint Pro are threaded to M4

1. Degrease the thread holes with rubbing alcohol.
2. Use the screws supplied by KE Arms marked L for Left and R for Right. The right screw is shorter than the left.
3. Test fit the screws first
4. If the right screw is too long it can impede on the action of the extractor plunger and rounds may fail to feed or fail to extract.
5. Look through the back of the slide to see if the screw is going into the extractor plunger hole.
6. Once you are satisfied that the screws fit and function properly, use blue locktite to secure them. Take care not to allow excess locktite to run into the slide.
7. Tighten the screws until pressure from one finger can cause the Allen wrench to bend in the stopped position.
8. Wait 24 hours after applying locktite before live fire with the slide.